Home > CCNP

Extended acl with packet tracer

Extended Access Lists Configuration With Packet Tracer In this lesson we will focus on Extended ACL Configuration with Packet Tracer. We will use the below topology for our packet tracer configuration. You can DOWNLOAD the Packet Tracer example with .pkt format HERE. Like Standard ACL configuration example, we will use one router, one destination server […]

standard acl configuration packet tracer

Standard Access List Configuration With Packet Tracer In this lsson we will see the standart access list and how to configure standart access list in Packet Tracer. There are three types Access Lists in common. Thse access list types are : – Standard Access List – Extended Access List – Named Access List You can […]

IPv6 Routing Protocols – Part 4 (RIPng)

Posted by gokhankosem on 07 Jun 17 - 0 Comments
RIP IPv6 RIPng topology

RIPng and RIPng Configuration On Cisco IOS RIP for IPv6 : RIPng (RIP Next Generation) RIPng (RIP Next Generation)is the IPv6 available next level protocol of RIPv2. In modern networks, generally RIP is not used and also RIPng. But as a basic protocol, generally RIP is discussed first. Here, we will start the IPv6 Routing […]

EIGRP Configuration with Packet Tracer

EIGRP Configuration With Packet Tracer ************************************************************ WouLd YoU LiKe To Learn How to Use PAcket TraceR and PracTice CCNA LAbs on PaCKet TrAcEr??? Here is My Courses on UDemY!! CISCO PACKET TRACER HOW TO GUIDE CISCO PACKET TRACER CCNA LABS ADVENTURE 1 CISCO PACKET TRACER CCNA LABS ADVENTURE 2 ************************************************************ EIGRP (Enhanced Interior Gateway Routing […]

EIGRP – Part 4 (Other EIGRP Properties)

Posted by gokhankosem on 02 Oct 16 - 0 Comments

Other EIGRP Properties In EIGRP Operation there are some protocol characteristics that helps you better implementation. These characteristics are mentioned below. Route Summarization By default EIGRP summarizes the classfull addresses. So generally “no auto-summary” command is used to avoid this situation. Router (config) # router eigrp 100 Router (config-router) # no auto-summary Summary routes can […]


Copy Protected by Chetan's WP-Copyprotect.