Home > Routing

OSPFv3 Configuration Example on Cisco IOS

Posted by gokhankosem on 26 Sep 17 - 0 Comments

OSPFv3 Configuration Example on Cisco IOS OSPFv3 is the IPv6 cabaple version of OSPF. The previous version of OSPF was OSPFv2. OSPFv2 is for IPv4. Here, we will configure OSPFv3 for the below topology. As you can see, there are three areas and six routers in this topology. For OSPFv3 configuration, we will follow the […]

IPv6 Routing Protocols – Part 4 (RIPng)

Posted by gokhankosem on 07 Jun 17 - 0 Comments
RIP IPv6 RIPng topology

RIPng (RIP Next Generation), RIP for IPv6 RIPng (RIP Next Generation)is the IPv6 available next level protocol of RIPv2. In modern large networks, generally RIP is not used and also RIPng. But as a basic protocol, it is still used in many small networks. Basically, the characteristics of these two version is same. As we […]

IPCisco-Cisco-Juniper-Alcatel-Huawei-CheatSheet

COMPARISON OF TOP FOUR VENDORS’S COMMAND LINE In IP world, there are many vendors. But some of these vendors are very common and widely used. These vendors are Cisco, Juniper, Alcatel-Lucent (Now Nokia) and Huawei. I have prepared a cheat sheet for comparison of these vendors’s command line. These document is especially for the Service […]

EIGRP Configuration with Packet Tracer

EIGRP Configuration With Packet Tracer ************************************************************ WouLd YoU LiKe To Learn How to Use PAcket TraceR and PracTice CCNA LAbs on PaCKet TrAcEr??? Here is My Courses on UDemY!! CISCO PACKET TRACER HOW TO GUIDE CISCO PACKET TRACER CCNA LABS ADVENTURE 1 CISCO PACKET TRACER CCNA LABS ADVENTURE 2 ************************************************************ EIGRP (Enhanced Interior Gateway Routing […]

EIGRP – Part 4 (Other EIGRP Properties)

Posted by gokhankosem on 02 Oct 16 - 0 Comments

Other EIGRP Properties In EIGRP Operation there are some protocol characteristics that helps you better implementation. These characteristics are mentioned below. Route Summarization By default EIGRP summarizes the classfull addresses. So generally “no auto-summary” command is used to avoid this situation. Router (config) # router eigrp 100 Router (config-router) # no auto-summary Summary routes can […]


Copy Protected by Chetan's WP-Copyprotect.