Home > Static Routing

IPv6 Static Routes (On Juniper Routers)

Archived in the category: Basic, IPv6, Juniper, Routing, Static Routing
Posted by gokhankosem on 20 Jun 12 - 2 Comments

On Juniper routers to create a static route for IPv6 we use “routing-options” hierarchy as IPv4. But this time after this hierarchy, we go under another hierarchy, “ rib inet6.0”. The below example will be a basic example of configuring IPv6 static routes on Juniper routers. As you see we have three routers again, and […]

IPv6 Static Routes (On Cisco Routers)

Archived in the category: Cisco, IPv6, Routing, Static Routing
Posted by gokhankosem on 20 Jun 12 - 2 Comments

On Cisco routers to create a static route for IPv6, we use the similar commands with IPv4. We can make this configuration with three ways : To send all packets to the next-hop address, ipv6 route 2001:dc8:b15:4::1/64 2001:dc8:b15:5::1/64 Directly attached static route to send packets out an interface, ipv6 route 2001:dc8:b15:4::1/64 fastethernet 0/0 Full specified […]

Default Routes and Floating Static Routes on Alcatel Routers

Archived in the category: Alcatel-Lucent, Routing, Static Routing
Posted by gokhankosem on 31 Mar 12 - 3 Comments

Default Routes and Floating Static Routes Default Routes Default routes are the routes that used by a router when there is no other route is known for a destination address. We can use the below picture. Here if to a destination there is no route on SR 1 then SR 1 will use the next […]

Static Routing with Alcatel-Lucent Service Routers As you know Alcatel-Lucent is another network device vendor like Cisco and Juniper. Here, we will see the static route configuration with Alcatel-Lucent routers. For this configuration, we will use one of the routers in Alcatel-Lucent’s Service Router family, 7750 SR-C4. The topology that we will use is below. […]

Juniper Static Route GNS3 Configuration Example

Static Route Configuration on Juniper Routers In this article we will focus on static route configuration on Juniper routers. Here, we will use Juniper JuNOS and we will be familiar with some JuNOS commands. The basic topology that we will use is below. We have three routers and two network. We will provide the route […]


Copy Protected by Chetan's WP-Copyprotect.