In IP world, there are many Network Equipment Vendors. But some of these Network Equipment Vendors are very Common in Network World and Well Known. These Well Known Vendors are :
– Cisco
– Juniper
– Nokia
– Huawei
I have prepared a cheat sheet for comparison of these Vendors’s Command Line. These document is especially for the Service Provider routers of these vendors.
Here, you will find some of the commands of :
– Cisco IOS, IOS XR
– Juniper Junos
– Nokia SROS
– Huawei HVRP
You can DOWNLOAD the document below…Enjoy and keep on IPCisco.com
Table of Contents
gokhankosem
Gokhan Kosem is a Network Engineer, Instructor and the Founder of IPCisco.com with 15+ years of experience in Cisco, Nokia, Huawei, Juniper, Linux, Service Provider Networks, Routing and Switching technologies.
He has worked on the backbone networks of major service providers and network vendors including Nortel, Alcatel-Lucent (Nokia) and has extensive hands-on experience with Cisco, Huawei, Juniper and Nokia networking technologies.
He has trained thousands of networking students worldwide through IPCisco.com, Udemy, books, labs, quizzes, and educational content across multiple social media platforms.
IPCisco.com | Best Route to Your Dreams
Thanks Gokhan this is really helpful
Thanks Gokhan this is really helpful
Good work thanks
It is better to add Brocade as the 3rd vendor with Cisco and Juniper.
Hello
I was reading your sheet, and noticed that some commands are missing on Huawei’s side. Here what i detected:
Cisco: show inventory
Huawei: display e-label
Cisco: show diags
Huawei: display diagnositc-information
Cisco: show policy-map
Huawei: Display qos policy interface
Cisco: clear access-list counters
Huawei: reset acl counter all
Hope this helps
Thank you very much Antonio :)
Valuable information. Appreciate it.
Hi Gokhan Kosem, thanks for sharing this stuff. It will be very helpful for me.
Lovely to see your increasing our knowledge thanks
What you are doing is great. I appreciate your contribution to Network Engineering.
I love this website so much, you have a lot of useful materials Mr Kosem.
good info,the show ( after config change) for huawei is
display this
clear line for ALU
admin disconnect