IPv4 Static Routing on Juniper Routers


Static Routing on Juniper Routers

Static Routing is the manual route configuration on routers. In JUNOS, static route configuration is done similarly with other Network operating systems.

After “static route” command, the destination network is mentioned and then next-hop ip address is given. This static route definition is done under “routing-options” hierarchy in JUNOS.

For our JUNOS Static Route Example, we will use the below simple topology.

juniper-junos@Kosem> configure [edit] juniper-junos@Kosem# edit routing-options [edit routing-options] juniper-junos@Kosem# set static route next-hop [edit routing-options] juniper-junos@Kosem# show static { route next-hop; } [edit routing-options] juniper-junos@Kosem# commit commit completeTo show the configured static route:

We're Sorry!

Full Access is for only IPCisco Crew...

With IPCisco Membership, You Can Access:

• All Certification Courses (Cisco, Juniper, Nokia and Huawei),
• Thousands of Questions (Lesson Quizes and Special Quiz Section),
• Carieer Consultancy, CV/Resume Check, Career Advice Meeting,
• Cheat Sheets, Job Interview Trainings, Network Tools,
You will be Member of a Big IPCisco Community,
You will Learn Network Lessons with Always,
New And Different Learning Styles!
We are waiting for you!

Lesson tags: Static Routing, junos, juniper
Back to: JNCIA Junos > Juniper JUNOS CLI