JNCIP Quiz 10 ⋆ IpCisco

JNCIP QUIZ 10

Please wait while the activity loads.
If this activity does not load, try refreshing your browser. Also, this page requires javascript. Please visit using a browser with javascript enabled.

If loading fails, click here to try again

CONGRATULATIONS!

YOU HAVE COMPLETED JNCIP QUIZ 10.

YOU HAVE %%SCORE%% TRUE ANSWERS OUT OF %%TOTAL%% QUESTIONS.

YOUR SCORE IS %%PERCENTAGE%%.

%%RATING%%

Your answers are highlighted below.

Question 1

How can we check IS-IS Topology Database?

A	show isis topology
B	show isis tables
C	show router isis database
D	show isis database
E	show router isis topology

Question 2

If we use .... RSVP command on Merge Point, we can see the Point of Local Repair address.

A	show rsvp associations
B	show rsvp peers
C	show rsvp interface
D	show rsvp sessions
E	show rsvp neighbor

Question 3

What is the configuration context that we configure Policies on JUNOS?

A	protocol-options
B	policy-options
C	system-options
D	routing-options
E	route-options

Question 4

Which ones are some of the area types of OSPF?

A	Backbone
B	Stub
C	Standard
D	NSSA
E	All of them

Question 5

How to configure Autonomous System Number of a Junipier Router? (ASN=64750)

A	set routing-options 64750
B	set routing asn 64750
C	set routing autonomous-system 64750
D	set routing asn 64750
E	set routing-options autonomous-system 64750

Question 6

The last three bits of DSCP in an IP Packet, shows ....

A	QoS priority
B	Class
C	Delay value
D	None of them
E	Drop probability

Question 7

STP .... State is the state, in which the root bridge and port roles are determined by sending and receiving BPDUs.

A	Listening
B	Learning
C	Active
D	Passive
E	Blocked

Question 8

How can we configure Loopback 0 address with 1.1.1.1 address?

A	set lo unit 0 inet address 1.1.1.1
B	set loopback inet address 1.1.1.1
C	set loopback unit inet address 1.1.1.1
D	set lo unit 0 family inet address 1.1.1.1
E	set lo unit 0 family inet 1.1.1.1

Question 9

Which information can be seen in the output of "show ospf interface" command?

A	Interface State
B	All of them
C	Area
D	BDR ID
E	DR ID

Question 10

Which Ones are some of the RSVP Messages?

A	ResvErr Messages
B	PathTear Messages
C	Notif Messages
D	ResvConfirm Messages
E	Keepalive Messages

Question 11

If we have two route to a destination with both Static Route and BGP, which one is selected?

A	BGP
B	Both
C	Static
D	None of them

Question 12

If you use .... for IPv6 Transition, you do not need to create tunnels.

A	Dual Stack
B	None of them
C	6in4
D	6to4
E	6rd

Question 13

How to enable packet based MPLS on a Juniper router?

A	edit protocols
B	set family mpls mode packet-based
C	set mpls mode packet-based
D	set mpls-mode packet-based
E	edit security forwarding-options

Question 14

What is Meeting Point of Receiver and Sender in a Multicast Network?

A	Randevous-Point
B	Designated Router
C	Source Segment
D	Querier
E	Receiver Segment

Question 15

VPN-IPv4 is consist of .... and ...

A	Route Distinguisher / Ipv4 Prefix
B	Route Distinguisher / MAC
C	Route Target / MAC
D	Route Target / Ipv4 Prefix
E	Route Target / Priority

Question 16

To set an interface with VLAN 5, we use .... command.

A	set 100 vlan 100
B	set 100 vlan-id 100
C	set vlan-id 100
D	set vlan 100
E	set unit 100 vlan-id 100

Question 17

Which ones are new LSA types used with IPv6 version of OSPF, OSPFv3?

A	LSA 6
B	LSA 7
C	LSA 8
D	LSA 5
E	LSA 9

Question 18

The General Query message is sent to the Multicast address ....

A	224.0.0.13
B	224.0.1.1
C	224.0.0.2
D	224.0.0.1
E	224.0.0.22

Question 19

The Protocol number of IGMP in an IP Packet is ....

A	100
B	1
C	10
D	2
E	5

Question 20

To mirror the content in router's flash to the hard drive, we use .... command.

A	show snapshot system
B	show snapshot
C	request system boot
D	request system snapshot
E	show system snapshot

Once you are finished, click the button below. Any items you have not completed will be marked incorrect. Get Results

There are 20 questions to complete.

gokhankosem

Gokhan Kosem is a Network Engineer, Instructor and the Founder of IPCisco.com with 15+ years of experience in Cisco, Nokia, Huawei, Juniper, Linux, Service Provider Networks, Routing and Switching technologies.

He has worked on the backbone networks of major service providers and network vendors including Nortel, Alcatel-Lucent (Nokia) and has extensive hands-on experience with Cisco, Huawei, Juniper and Nokia networking technologies.

He has trained thousands of networking students worldwide through IPCisco.com, Udemy, books, labs, quizzes, and educational content across multiple social media platforms.

IPCisco.com | Best Route to Your Dreams

JNCIP Quiz 10

JNCIP QUIZ 10

Latest Lessons

Latest Blog Posts

WHAT YOU WILL FIND?

COURSES

SPECIALS

MEMBERSHIP