Huawei Static Routing and Load Balancing ⋆ IpCisco

Table of Contents

Huawei Static Routing

Static Route is a manual simple route configuration. In Huawei Routers, Static Routing is similar to the other platforms like Cisco Static Routing, Nokia Static Routing etc.

The concept is simple:

Write “ip static route”
Add “the Destination IP and Subnet Mask”
Add “the Gateway”

HCNA Course

You can download this configuration on Huawei eNSP Labs Page.

Huawei Static Route Configuration Example

Here, we will show Huawei Static Route Configuration on the below topology.

As you can see, we have two routers and two different networks that the other end router do not know. So, with Static Route Configuration, we will show “how to reach that far network” to each router. We will configure firstly Router 1 and then Router 2.

On Router 1, we will do one of the below Huawei Static Routing Configurations. These three configuration is same. It is up to your configuration behaviour.

system-view
[Huawei-Router1] ip route-static 10.10.30.0 255.255.255.0 172.16.0.2

system-view
[Huawei-Router1] ip route-static 10.10.30.0 255.255.255.0 GigabitEthernet 1/1/1