CCNA Quiz 2 ⋆ IpCisco

CCNA QUIZ 2

Please wait while the activity loads.
If this activity does not load, try refreshing your browser. Also, this page requires javascript. Please visit using a browser with javascript enabled.

If loading fails, click here to try again

CONGRATULATIONS!

YOU HAVE COMPLETED CCNA QUIZ 2.

YOU HAVE %%SCORE%% TRUE ANSWERS OUT OF %%TOTAL%% QUESTIONS.

YOUR SCORE IS %%PERCENTAGE%%.

%%RATING%%

Your answers are highlighted below.

Question 1

In a router, we can determine authentication mode in three ways, these are:

A	authentication-mode aaa-server
B	authentication-mode aaa
C	authentication-mode password
D	authentication-mode authentication
E	authentication-mode none

Question 2

How to make an interface as Trusted for DHCP Snooping?

ccna dhcp snooping trusted interface question

A	ip dhcp snooping trust
B	ip dhcp trust
C	dhcp trust enable
D	ip snooping enable
E	ip snooping trust

Question 3

With .... VPN type company sites which are in geographically different places are connected over internet securily.

A	Company
B	Enterprise
C	Normal Access
D	Site to Site
E	Remote Access

Question 4

Which ones are the states of RPVST+?

A	Forwarding
B	Blocking
C	All of them
D	Disabled
E	Learning

Question 5

Which wireless protocol is the most strong one?

A	WPA3
B	WPA
C	None of them
D	WEP
E	WPA2

Question 6

Default Administrative Distance of Static routes is ... for Cisco.

A	1
B	5
C	10
D	255
E	0

Question 7

Router looks to .... for boot system.

A	CPU
B	ROM
C	Flash
D	NVRAM
E	RAM

Question 8

To Manage network devices, ... protocol is used.

A	OSPF
B	FTP
C	RSTP
D	SNMP
E	SMTP

Question 9

.... is a network configuration management protocol used with SDN instead SNMP.

A	Open Flow
B	Netconf
C	SMTP
D	Rest
E	None of them

Question 10

Which Access Point Mode is the default mode?

A	Rogue Detector
B	Flexconnect Mode
C	Monitor Mode
D	Bridge Mode
E	Local Mode

Question 11

First 3 bits of DSCP is used as ...

A	Policing
B	CIR
C	Class Selector Codepoint
D	Drop probability
E	Marking

Question 12

Which ones are some of the Malware Attacks?

A	Adware
B	All of them
C	Viruses
D	Trojan Horses
E	Worms

Question 13

OSPF uses ... algorithm to calculate Shortest Path.

A	Bellman-Ford
B	None of Them
C	Policy Based
D	Dual
E	Dijkstra

Question 14

Which ones are Link State Routing protocols?

A	RIP
B	EIGRP
C	OSPF
D	IS-IS
E	BGP

Question 15

.... is the time taken from one point to the other along the path.

A	PIR
B	Delay
C	Packet Loss
D	Jitter
E	CIR

Question 16

What is the default sequence for loading IOS?

A	TFTP, FLASH, ROM
B	FLASH, ROM, TFTP
C	NVRAM, TFTP, FLASH
D	NVRAM, TFTP, CONSOLE
E	FLASH, TFTP, ROM

Question 17

Which of the following Protocols uses UDP?

A	DNS
B	SMTP
C	FTP
D	TFTP
E	HTTP

Question 18

If Dynamic ARP Inspection (DAI) is enabled, .... is cheched and then if the incoming MAC address is in this table, this ARP Packet is accepted.

A	MAC Table
B	RIB Table
C	IP-MAC Binding Table
D	Routing Table
E	None of Them

Question 19

How to configure default route to 2001:ABC:33:44::1?

A	ip static route ::/0 2001:ABC:33:44::1
B	ipv6 ::/0 2001:ABC:33:44::1
C	ipv6 static-route ::/0 2001:ABC:33:44::1
D	static-route ::/0 2001:ABC:33:44::1
E	ipv6 route ::/0 2001:ABC:33:44::1

Question 20

MAC Address is ... Bits Long.

A	64
B	48
C	128
D	32
E	24

Question 21

There are 5 VLANs on a Switch. How many Broadcast Domains are there for these VLANs?

ccna vlan broadcast domain question ipcisco

A	10
B	None of them
C	5
D	2
E	1

Question 22

Which ones are used with NAT?

A	All of them
B	Inside global
C	Inside local
D	Outside global
E	Outside local

Question 23

Which of the below protocols are Routed protocols?

A	OSPF
B	STP
C	IP
D	RIP
E	VTP

Question 24

How to set syslog server of a router as 1.1.1.1?

A	log-server 1.1.1.1
B	server 1.1.1.1 logging
C	server-id 1.1.1.1
D	logging 1.1.1.1
E	server 1.1.1.1 logging enable

Question 25

Default network mask for Class B IPv4 address is ....

A	255.255.255.0
B	255.255.255.255
C	None of Them
D	255.255.0.0
E	255.0.0.0

Question 26

Which router command is used to identify traffic bottlenecks between two points?

ccna traffic bottlenecks question ipcisco

A	SSH
B	Trace
C	Telnet
D	Ping
E	Debug

Question 27

Which ones are Cisco Wireless Controller Models?

A	Catalyst 9800-40
B	Catalyst 9800-CL
C	Catalyst 9800-L
D	All of them
E	Catalyst 9800-80

Question 28

Which command turns on a Cisco router interface?

A	activete
B	no shutdown
C	shutdown
D	enable
E	run

Question 29

Which subnet mask can be showed with /20?

A	255.255.240.0
B	255.255.128.0
C	255.255.252.0
D	255.255.248.0
E	255.255.224.0

Question 30

Which one is the Cisco proprietary Neighbour Discovery Protocol?

A	IGMP
B	ICMP
C	CDP
D	LLDP
E	CGMP

Question 31

.... HTTP status code means the url is permanently redirected to a new URL.

A	301 (Moved Permanently)
B	200 (OK)
C	500 (Internal Server Error)
D	404 (Unauthorized)
E	401 (Unauthorized)

Question 32

Which ones are two of the REST API information parameters?

A	Tail
B	Option
C	Tag
D	Header
E	Verb

Once you are finished, click the button below. Any items you have not completed will be marked incorrect. Get Results

There are 32 questions to complete.

gokhankosem

Gokhan Kosem is a Network Engineer, Instructor and the Founder of IPCisco.com with 15+ years of experience in Cisco, Nokia, Huawei, Juniper, Linux, Service Provider Networks, Routing and Switching technologies.

He has worked on the backbone networks of major service providers and network vendors including Nortel, Alcatel-Lucent (Nokia) and has extensive hands-on experience with Cisco, Huawei, Juniper and Nokia networking technologies.

He has trained thousands of networking students worldwide through IPCisco.com, Udemy, books, labs, quizzes, and educational content across multiple social media platforms.

IPCisco.com | Best Route to Your Dreams

CCNA Quiz 2

CCNA QUIZ 2

Latest Lessons

Latest Blog Posts

WHAT YOU WILL FIND?

COURSES

SPECIALS

MEMBERSHIP