GLBP Configuration on Cisco

GLBP-example

GLBP Configuration on Cisco

GLBP is a Cisco Proprietary Firsth Hop Redundancy Protocol. In this lesson, we will configure GLBP on Cisco devices with a GLBP Example Topology.

For our GLBP Example, we will use the below topology.


GLBP-example-topology

To configure GLBP, there are some steps. These steps are given elow one by one:

1. Interface Configurations
2. GLBP Group Configuration with Group ID and Virtaul IP
3. GLBP Priority Configuration
4. Setting GLBP Preeption
5. Setting GLBP Load Balancing Option
6. Saving the configuration
7. GLBP Verification

Now, let’s start and learn How to Configure GLBP practically.

Interface Configurations

Interface configuration is the basic IP configurations of switch ports. Here, our swicthes are Layer 3 switch.

Switch A# configure
Switch A(config)# interface Gigabitethernet 1/1/1
Switch A(config-if)# ip address 10.10.10.1 255.255.255.0
Switch A(config-if)# no shutdown
Switch B# configure
Switch B(config)# interface Gigabitethernet 1/1/1
Switch B(config-if)# ip address 10.10.10.2 255.255.255.0
Switch B(config-if)# no shutdown

We're Sorry!
Full Access is for only IPCisco Crew...
With IPCisco Membership, You Can Access:
• All Certification Courses (Cisco, Juniper, Nokia and Huawei),
• Thousands of Questions (Lesson Quizes and Special Quiz Section),
• Carieer Consultancy, CV/Resume Check, Career Advice Meeting,
• Cheat Sheets, Job Interview Trainings, Network Tools,
You will be Member of a Big IPCisco Community,
You will Learn Network Lessons with Always,
New And Different Learning Styles!
We are waiting for you!

Lesson tags: FHRP, Redundancy, cisco IOS, packet tracer, cisco packet tracer, GLBP
Back to: Cisco Hands On Course (With Packet Tracer) > First Hop Redundancy Configurations

Comments are closed.

Cisco Hands On Course (With Packet Tracer)