LACP Configuration on Cisco Devices


We have learned LACP and Link Aggregation before detailly and in this article we will focus LACP Cisco Configuration. We will make a link aggregation protocol with two ports in one bundle. You can use more port up to 8 ports in Cisco devices.


Link aggregation Example Topology on Cisco
Link Aggregation on Cisco Devices
In our LACP Cisco Configuration example, we will use the G1/0/0 and the G2/0/0 ports to configure link aggregation. The basic configuration steps are below.



On RouterA

RouterA> enable
RouterA# configure terminal
RouterA (config)# interface port-channel 1
RouterA (config-if)# lacp max-bundle 2
RouterA (config-if)# ip address
RouterA (config-if)# interface g1/0/0
RouterA (config-if)# no ip address
RouterA (config-if)# channel-group 1 mode active
RouterA (config-if)# exit
RouterA (config)# interface g2/0/0
RouterA (config-if)# no ip address
RouterA (config-if)# channel-group 1 mode active
RouterA (config-if)# end


You can also view the below LACP Configuration Lessons for different vendors:

Lesson tags: cisco IOS, Etherchannel, LAG, packet tracer, cisco packet tracer, LACP
Back to: Cisco Packet Tracer Lab Course > EtherChannel Configurations

Leave a Reply

Your email address will not be published. Required fields are marked *

IPCisco is the Winner of 2019 “Best Certification Study Journey” Category! We are also Finalist of 2020 & 2021 in Cisco IT Blog Awards!


Cisco Packet Tracer Lab Course

IPCisco on Social Media!