LACP Configuration on Juniper Devices

Link-Aggregation-Juniper

How to Configure LACP on Juniper Routers

 

We have talked about LACP in the previous articles on Cisco Routers. Here we will focus on how to do LACP Configuration on Juniper devices on ethernet links. We will learn LACP Configuration on Juniper. As you know the protocol is the same, but there are some configuration differencies between different vendor’s devices.

 

By the way, we do not need to use LACP for ethernet bundlings, this is only a way with LACP protocol.

 

By default, there can be also maximum 8 ports in a bundle on Juniper devices. This can be changed by commands. The typical usage of the LAG is to aggregate trunk links, between the access switch and the distribution switch.

 

Link Aggregation Example Topology on Juniper, JUNOS
Link Aggregation on Juniper Devices
In Juniper swithes, for aggregated links, firstly we need to configure, aggregated Etnernet interfaces.

[edit chassis]

gk@switch# set aggregated-devices interfaces device-count 1

After creating aggregated Ethernet interfaces, it is time to define minimum link count while the bundle is up. To do this use the below command:

[edit interfaces]
gk@switch# set interface-name aggregated-ether-options minimum-links 3

 

You can also view the below Link Aggregation Configuration Lessons for different vendors:

Lesson tags: Link Aggregation, LACP
Back to: JNCIS > High Availability

Leave a Reply

Your email address will not be published.

IPCisco is the Winner of 2019 “Best Certification Study Journey” Category! We are also Finalist of 2020 & 2021 in Cisco IT Blog Awards!

Cisco-ITBlogAwards-2019-Winner-IPCisco-k
ITBlogAwards_2020_Badge-Finalist-BestCertStudy-ipcisco
ITBlogAwars-2021-ipcisco
IPCisco on Social Media!

Latest Blog Posts

global-mobile-data-traffic-2027-2026
14-Ways-To-Study-CCNA-Online
top-ten-network-certifications-ipcisco
metaverse-jobs-ipcisco.com
Wifi-6-vs-wifi-5-ipcisco.com