Packet Types of IS-IS

isis-helllos-ipcisco

IS-IS Packet Types

IS-IS Protocol uses L2 encapsulation Ethernet 802.3/802.2. It do not use Ethernet II. Ethernet II is used for IP traffic.

IS-IS Protocol exchanges protocol information by using Link-State PDUs (Protocol Data Units).

There are four types of PDU packets in IS-IS Protocol.

These IS-IS packets are :

– IS-IS Hello PDU (IIH)
– Link State PDU (LSP)
– Partial Sequence Number PDU (PSNP)
– Complete Sequence Number PDU (CSNP)

In IS-IS PDUs there is a TLV (Type, Length, Value) field. According to the need, these fields are added to the PDUs. This TLV field makes IS-IS extendable and it is the major advantage of IS-IS over OSPF. There are several TLVs in IS-IS packets. IS-IS Header always same, but according to the type of the packet, added TLV fields change.

TLVs are maximum 256 bytes and they contains sub-TLVs.

IS-IS Header Format, ISIS TLVs

IS-IS Header Format

IS-IS discovers the IS-IS neighbours and IS-IS adjacency via Hello PDUs. DIS election is also done with this PDUs.

There are three types Hello PDUs in IS-IS Protocol:

ESH -> ES sent to IS
ISH -> IS sent to ES
IIH -> Between two ISs

IS-IS Hellos, ESH, ISH, IIH

IS-IS Hellos, ESH, ISH, IIH

IS-IS Hello interval is 10 seconds and the dead interval is 30 seconds by default.

In IS-IS Hello packet, 6 types of data can be included with TLVs. These are:

– Area Addresses TLV
– Padding TLV
– IP Interface Address TLV
– Authentication Information TLV
– Protocols Supported TLV
– Intermediate System Neighbors TLV

For more information about IS-IS TLVs, you can check Intermediate System-to-Intermediate System (IS-IS) TLVs article on Cisco Website.

IS-IS LSPs are like LSAs in OSPF and contains many information about the neighbour ISIS Routers and links. They are flooded periodically in IS-IS network. L1 and L2 PDUs use different formats LSPs are stored in IS-IS LSDBs. Seperate datababses are used for L1 and L2 LSPs. Each LSP has sequence number that shows its version.

In LSPs, below TLVs are supported:

– Area Addresses TLV
– Originating LSP Buffer Size TLV
– Intermediate System Neighbors TLV
– End System Neighbor TLV
– Authentication Information TLV
– Prefix Neighbor TLV
– Protocols Supported TLV
– IP Interface Address TLV
– IP Internal Reachability Information TLV
– IP External Reachability Information TLV

Lesson tags: routing, is-is
Back to: JNCIS > IS-IS
Comments are closed.