RIPng Configuration Example on Cisco IOS

RIPng-example-topology-2

RIPng Cisco Configuration

The configuration of RIPng is a little different from its predecessor, RIPv2. First of all, RIPng is IPv6 avare routing protocol and before RIPng Cisco configuration, IPv6 must be configured in your system.

In this article, we will configure RIPng Cisco according to the below topology.

RIPng-example-topology

Here, for Cisco RIPng configuration there are two steps. These steps are:

1) Enabling CEF, IPv6 and RIPng globally,
2) Enabling RIPng for the specific interface.


You can also check IPv6 Questions Page.


Enabling CEF, IPv6 and RIPnG on Routers

Firstly we will enable CEF with “ip cef” command and again we will enable IPv6 routing with “ipv6 unicast-routing” command. After this we need to create RIPng with a name by “ipv6 router rip ripname” command.

Router1# configure terminal
Router1(config)# ip cef
Router1(config)# ipv6 unicast-routing
Router1(config)# ipv6 router rip CompanyNetworkRIP
Router2# configure terminal
Router2(config)# ip cef
Router2(config)# ipv6 unicast-routing
Router2(config)# ipv6 router rip CompanyNetworkRIP
Router3# configure terminal
Router3(config)# ip cef
Router3(config)# ipv6 unicast-routing
Router3(config)# ipv6 router rip CompanyNetworkRIP


You can also learn How to Configure RIPng on Huawei Routers


Enabling Interfaces for RIPnG on Routers

After these, the second step is enabling the interfaces for RIPng. In RIPv2, networks are become RIP available via network command. But in RIPng, the configuration is done via interfaces not networks.


Router 1 RIPng Configuration

Router1(config)# interface Loopback0
Router1(config-if)# no ip address
Router1(config-if)# ipv6 enable
Router1(config-if)# ipv6 address 1111:A:A:A::1/128
Router1(config-if)# ipv6 rip CompanyNetworkRIP enable
Router1(config-if)# exit
Router1(config)# interface FastEthernet0/0
Router1(config-if)# no ip address
Router1(config-if)# duplex auto
Router1(config-if)# speed auto
Router1(config-if)# ipv6 enable
Router1(config-if)# ipv6 address 1111:1:1:1::1/64
Router1(config-if)# ipv6 rip CompanyNetworkRIP enable
Router1(config)# interface FastEthernet0/1
Router1(config-if)# no ip address
Router1(config-if)# duplex auto
Router1(config-if)# speed auto
Router1(config-if)# ipv6 enable
Router1(config-if)# ipv6 address 1111:2:2:2::1/64
Router1(config-if)# ipv6 rip CompanyNetworkRIP enable

Router 2 RIPng Configuration

Lesson tags: IPv6, cisco IOS, packet tracer, cisco packet tracer, routing, ripng
Back to: Cisco Packet Tracer Lab Course > Routing Protocol Configurations (IPv6)
Comments are closed.

Cisco Packet Tracer Lab Course

Collapse
Expand