RIPng Configuration on Huawei

huawei-ripng-configuration

RIPng Configuration on Huawei

In this lessons we will talk about the basic Routing Protocol of IPv6, RIPng. We will focus RIPng Configuration on Huawei routers.

For our RIPng Configuration Example, we will use the below RIPng Network Topology:


huawei-ripng-configuration
Let’s start our RIPng Configuration on these three Huawei Routers.

Firstly, we will enable IPv6 and we will create RIPng with process ID globally on Router 1.

system-view
[Huawei-Router-1] ipv6
[Huawei-Router-1] ripng 1

Then, we will enable IPv6 on the interfaces that we would like to run RIPng and we will set the IPv6 address. Here, we will configure our routers to use automatic link-local addresses.

[Huawei-Router-1] interface GigabitEthernet 0/0/0
[Huawei-Router-1- GigabitEthernet0/0/0] ipv6 enable
[Huawei-Router-1- GigabitEthernet0/0/0] ipv6 address auto link-local

After that, we will configure RIPng under the interface.

[Huawei-Router-1- GigabitEthernet0/0/0] ripng 1 enable
[Huawei-Router-1- GigabitEthernet0/0/0] quit

We will also do the same configuration on the other interface that will run RIPng.

We're Sorry!

Full Access is for only IPCisco Crew...

With IPCisco Membership, You Can Access:

• All Certification Courses (Cisco, Juniper, Nokia and Huawei),
• Thousands of Questions (Lesson Quizes and Special Quiz Section),
• Carieer Consultancy, CV/Resume Check, Career Advice Meeting,
• Cheat Sheets, Job Interview Trainings, Network Tools,
You will be Member of a Big IPCisco Community,
You will Learn Network Lessons with Always,
New And Different Learning Styles!
We are waiting for you!

Other RIP Lessons

Lesson tags: HCNA, Huawei, rip, routing
Back to: HCNA > RIP

HCNA