VLAN Routing with Layer 3 Switch on Huawei

huawei-vlan-routing-l3-switch

VLAN Routing with Layer 3 Switch on Huawei

We do not need any other Layer 3 device for VLAN Routing with Layer 3 Switch. Because Layer 3 switch can achieve this routing facility. Here, instead of subinterface, “VLANIF” is created for each VLAN.

Our example topology is below:


huawei-vlan-routing-l3-switch

This VLANIF is used as the gateway of each VLAN.So, we have 3 VLANs and we need to create 3 VLANIF.

Let’s start the configuration.

Layer 3 Switch Configuration for VLAN Routing

Firstly we will configure, each interfaces of the L3 Switch. We will set these interfaces as access and we will give their default VLAN.

[Huawei-Switch] interface GigabitEthernet0/0/1
[Huawei-Switch-GigabitEthernet0/0/1] port link-type access
[Huawei-Switch-GigabitEthernet0/0/1] port default vlan 10
[Huawei-Switch-GigabitEthernet0/0/1] quit
[Huawei-Switch] interface GigabitEthernet0/0/2
[Huawei-Switch-GigabitEthernet0/0/2] port link-type access
[Huawei-Switch-GigabitEthernet0/0/2] port default vlan 20
[Huawei-Switch-GigabitEthernet0/0/2] quit

We're Sorry!

Full Access is for only IPCisco Crew...

With IPCisco Membership, You Can Access:

• All Certification Courses (Cisco, Juniper, Nokia and Huawei),
• Thousands of Questions (Lesson Quizes and Special Quiz Section),
• Carieer Consultancy, CV/Resume Check, Career Advice Meeting,
• Cheat Sheets, Job Interview Trainings, Network Tools,
You will be Member of a Big IPCisco Community,
You will Learn Network Lessons with Always,
New And Different Learning Styles!
We are waiting for you!

Lesson tags: VLAN Routing, Huawei
Back to: HCNA > VLAN Routing

HCNA