RIPng Configuration on Huawei


RIPng Configuration on Huawei

In this lessons we will talk about the basic Routing Protocol of IPv6, RIPng. We will focus RIPng Configuration on Huawei routers.

For our RIPng Configuration Example, we will use the below RIPng Network Topology:

Let’s start our RIPng Configuration on these three Huawei Routers.

Firstly, we will enable IPv6 and we will create RIPng with process ID globally on Router 1.

[Huawei-Router-1] ipv6
[Huawei-Router-1] ripng 1

Then, we will enable IPv6 on the interfaces that we would like to run RIPng and we will set the IPv6 address. Here, we will configure our routers to use automatic link-local addresses.

[Huawei-Router-1] interface GigabitEthernet 0/0/0
[Huawei-Router-1- GigabitEthernet0/0/0] ipv6 enable
[Huawei-Router-1- GigabitEthernet0/0/0] ipv6 address auto link-local

After that, we will configure RIPng under the interface.

[Huawei-Router-1- GigabitEthernet0/0/0] ripng 1 enable
[Huawei-Router-1- GigabitEthernet0/0/0] quit

We will also do the same configuration on the other interface that will run RIPng.

We're Sorry!
Full Access is for only IPCisco Crew...
With IPCisco Membership, You Can Access:
• All Certification Courses (Cisco, Juniper, Nokia and Huawei),
• Thousands of Questions (Lesson Quizes and Special Quiz Section),
• Carieer Consultancy, CV/Resume Check, Career Advice Meeting,
• Cheat Sheets, Job Interview Trainings, Network Tools,
You will be Member of a Big IPCisco Community,
You will Learn Network Lessons with Always,
New And Different Learning Styles!
We are waiting for you!

Other RIP Lessons

Routing Information Protocol – RIP Overview
Routing Information Protocol – RIP Configuration With Packet Tracer
Routing Information Protocol – RIP Configuration on Juniper
Routing Information Protocol – RIPng Overview
Routing Information Protocol – RIPng Confiugration on Cisco IOS
Routing Information Protocol – RIPng Configuration on Huawei

Lesson tags: IPv6, routing, ripng, ipv6 routing
Back to: IPv6 Course > RIPng

Comments are closed.