Table of Contents
Static Routing on Juniper Routers
Static Routing is the manual route configuration on routers. In JUNOS, static route configuration is done similarly with other Network operating systems.
After “static route” command, the destination network is mentioned and then next-hop ip address is given. This static route definition is done under “routing-options” hierarchy in JUNOS.
For our JUNOS Static Route Example, we will use the below simple topology.
Other Static Routing Lessons on Other Vendors
IPv4 Static Route Configuration on Cisco
IPv6 Static Route Configuration on Cisco
IPv6 Default Route Configuration on Cisco
IPv4 Static Route Configuration on Juniper
IPv6 Static Route Configuration on Juniper
IPv6 Static Route Configuration on Juniper
IPv4 Static Route Configuration on Nokia
IPv4 Default and Floating Route Configuration on Nokia
St Route Configuratioatic Route on Huawei and Load Balancing
IPv4 Default and Floating Route Configuration on Huawei
Leave a Reply