Spanning Tree Protocol

l2-redundancy-broadcast-storm

STP Overview

In Layer 2 domain, redundancy is an important case. To provide redundant links, multiple connections are done between switches. But this redundancy mechanism can cause an undesirable situation that is called “L2 Loop”. To provide L2 redundancy and to avoid L2 loops, Spanning Tree Protocol (STP) has been developed. In this lesson we will focus STP Overview. In another lesson we will focus STP Configuration.

 

During the development period, various versions of STP has been introduced. Different standards has been created beside Cisco specific versions. These STP versions are :

 

  • STP (Spanning Tree Protocol) – 802.1D
  • RSTP(Rapid Spanning Tree Protocol) – 802.1W
  • PVST+(Per VLAN Spanning Tree Plus) – Cisco Proprietary
  • Rapid PVST+(Rapid Per VLAN Spanning Tree Plus) – Cisco Proprietary
  • MST(Multiple Spanning Tree) – 802.1s

 

In this article, mainly we will focus on STP (802.1D).

 


 

Redundant Layer 2 Problems

Redundancy is an important term for a network. Layer 2 Redundancy is also important but need more caution. Without a mechanims like STP, Layer 2 Redundancy mechanisms can cause the below problems:

• Layer 2 Loops and Broadcast Storms
• MAC Address Instability
• Duplicate Frame Transmission

Let’s talk about each of these Layer 2 Redundacy problems.

 


 

Layer 2 Loops and Broadcast Storms

Layer 2 Loops can occur when there is a multiple available Layer 2 link and this links also send and receive frames more than one. And because of the fact that, there is no TTL mechanims in Layer 2, Layer 2 Loops occurs. As you remember, in Layer 3, there is a TTL mechanism.

Think about the below topology:

l2-redundancy-broadcast-storm

 

Here, when Switch A receives a frame from Segment 1 and send it to the Segment 2, Switch B also can learn it from Segment 2. And it also sends this frame to Segment 1 as if it is being done first time. So, frames are doubled and a Layer 2 Loop Occured. And this Layer 2 loop causes a Broadcast Storm. An infinite frame send/receive process occurs.

 

One loop in a Layer 2 domain can cause one more Alyer 2 loops even if the siwtched network is a large network.

 


 

MAC Address Instability

This Loops also cause a MAC Instability issue. As you remember, source address of a frame is important for MAC address types. These tables are created with source ports and MAC addresses. During a Loop, a frame can be received from different sources. So MAC Instability problem occurs. Here, a MAC table can have multiple MAC addresses for the same ports. This is an undefinable case for switches.

l2-redundacy-mac-table-instability


 

Multiple Frame Transmission

Multiple Frame Transmission is the problem of multiple, unnecessariliy transfer of Layer 2 frames. Because of there are multiple paths to a destination, same frame can be sent through different ways and this causes multiple frame transmission.

l2-redundacy-multiple-frame-transmission


 

How STP Avoid Layer 2 Loops?

Lesson tags: STP, Spanning Tree
Back to: JNCIE > Ethernet Switching and STP

Leave a Reply

Your email address will not be published. Required fields are marked *

Contact

  • info@ipcisco.com
IPCisco is the Winner! “Best Certification Study Journey of 2019!”

Cisco-ITBlogAwards-2019-Winner-IPCisco-k

JNCIE