BGP Path Attributes – Weight


BGP Path Attributes – Weight Attribute

Weight Attribute is a Cisco proprietary BGP Path Attribute that is the first step in the BGP Best Path Selection Algorithm. In Cisco devices, BGP firstly check the Weight Attribute value and prefer the Highest Weight Attribute value. Then BGP Best Path selection continues with Local Preference and so on. If the device is not Cisco, this attribute is not important for you. You will start directly with Local Preference Attribute. value to select the BGP Best Path in all other vendor products.

During BGP Weight Attribute Configuration, different interfaces of the router are assigned different Weight values. The interface with the highest Weight value is selected and the traffic goes through this interface. Weight value is local on a router that it is configured and it does not exchanged between routers.

The highest Weight value is selected always as BGP Best Path or Best Route, if there are multiple routes to the same destination.

Weight value can be between 0 and 65535. By default the learned routes has a Weight value 0. This default value is 32768 for locally injected routes.

This Cisco Proprietary BGP Path Attribute can be assigned in three ways:

• By neighbor command
• By AS-Path Access-Lists
• By Route Maps

Let’s give an example for each of these ways.

You can also test yourself on BGP Quizes Section for your BGP Path Attribute knowledge.

BGP Weight Attribute Configuration Example

For our Weight Example, as a reference topology, we will use the below basic topology:

bgp path attribute, weight

BGP Path Attribute, Weight

In this example, we will see each path attribute assign way one by one.

Using Neighbor Command

Think about that, you will assign the Cisco proprietary BGP Path Attribute Weight value 100 towards a neighbour, Weight value 200 towards other neighbour and Weight value 300 towards another neighbour.

By neighbour command, you can assign Weigh Attribute values like below:

RouterA(config)# router bgp 10
RouterA(config-router)# neighbor weight 100
RouterA(config-router)# neighbor weight 200
RouterA(config-router)# neighbor weight 300

Here, the ip addresses is not showed in picture, because this is not our main concentrated point.

By doing this, you are saying to the RouterA that, Best BGP Path is through RouterD. “Go through Router D”.

Using AS-Path Acess-Lists

You can also configure the same properties by using AS-Path Access-Lists. The AS-Path Access-Lists configuration of the same weight configuration is like below:

RouterA(config)# router bgp 10
RouterA(config-router)# neighbour remote-as 10
RouterA(config-router)# neighbour filter-list 1 weight 100
RouterA(config-router)# neighbour remote-as 20
RouterA(config-router)# neighbour filter-list 2 weight 200
RouterA(config-router)# neighbour remote-as 30
RouterA(config-router)# neighbor filter-list 3 weight 300
RouterA(config-router)# exit
RouterA(config)# ip as-path access-list 2 permit ^10$
RouterA(config)# ip as-path access-list 2 permit ^20$
RouterA(config)# ip as-path access-list 3 permit ^30$

Lesson tags: BGP, path attributes, weight
Back to: CCNP Enterprise 350-401 ENCOR > BGP

Leave a Reply

Your email address will not be published. Required fields are marked *


IPCisco is the Winner! “Best Certification Study Journey of 2019!”


CCNP Enterprise 350-401 ENCOR