Cisco Single Area OSPF Configuration

single area ospf

OSPF Cisco Configuration

OSPF (Open Shortest Path First) protocol is a well-known routing protocol that is widely used today. To configure a network for OSPF properly there are some steps. For basic OSPF Cisco Configuration, the following scenario will be a good example.

 

single area ospf configuration topology with packet tracer
Single Area OSPF Configuration Topology

 


You can also learn DHCP Server Configuration With Packet Tracer


 

Cisco OSPF Configuration Steps

First of all, we will configure the routers’ interfaces. After that we will configure OSPF as our Routing Protocol. Here we assume that all the interfaces including loopback interfaces, their speed, duplex and descriptions have been configured.

 

To do OSPF Cisco Configuration, follow the below steps:

 

Enabling OSPF Process

In the router A, we will enable OSPF Process, with Process Number “1“.

 

A(config)# router ospf 1
A(config-router)#

 


Adding OSPF Networks

After enabling OSPF process on our Cisco Router A, then, we will add our networks that will be in OSPF network with their wildcard masks.

 

A(config-router)# network 10.10.10.0 0.0.0.255 area 0
A(config-router)# network 10.10.11.0 0.0.0.255 area 0
A(config-router)# end

 


Saving OSPF Config

To save our configuration, we will use “copy running-config startup-config” command.

 

A # copy running-config startup-config

 


OSPF Config on Router B

We will configure Router B like Router A. We will enable OSPF and then add OSPF Networks.

 

B(config)# router ospf 1
B(config-router)# network 10.10.11.0 0.0.0.255 area 0
B(config-router)# network 10.10.12.0 0.0.0.255 area 0
B(config-router)# exit
B # copy running-config startup-config

 


OSPF Config on Router C

We will configure Router C like Router A. We will enable OSPF and then add OSPF Networks.

 

C(config)# router ospf 1
C(config-router)# network 10.10.10.0 0.0.0.255 area 0
C(config-router)# network 10.10.12.0 0.0.0.255 area 0
C(config-router)# network 10.10.13.0 0.0.0.255 area 0
C(config-router)# end
C# copy running-config startup-config

 

You can download “Cisco Packet Tracer” in Tools section.

Lesson tags: ospf, routing
Back to: CCNP Enterprise 350-401 ENCOR v1.1 > OSPF

Leave a Reply

Your email address will not be published. Required fields are marked *

CCNP Enterprise 350-401 ENCOR v1.1

Collapse
Expand