LLDP Configuration Example

lldp-neighbour-discovery

In this configuration lesson, we will focus on Cisco LLDP Configuration. To understand LLDP better, let’s check the configuration of LLDP on the Cisco IOS. The most important commands related with LLDP configuration is showed below.

 

LLDP Configuration Topology
LLDP Configuration Topology
LLDP is disabled by default. To enable LLDP on the device, use “lldp run” on the global configuration mode. Again, “no lldp run” is used to disable lldp on that device.

 

RouterA(config)# lldp run

RouterA(config)# no lldp run

 


 

To specify the TLVs on the device, use “lldp med-tlv-select tlv” command. Here, tlv can be inventory-management, power-management, network-policy, location etc.

 

RouterA(config)# lldp med-tlv-select tlv

 


 

Like other protocols, LLDP (Link Layer Discovery Protocol) has also timers. The default values of reinit is 2, timer is 30 and holdtime is 120. Reinit is the initialization delay. Timer is the update time. And holdtime is the time that it waits without an update and then discards the entry.

 

LLDP timers can be configured like below:

 

Lesson tags: neighbor discovery, lldp
Back to: CCIE Enterprise Infrastructure > Neighbor Discovery

Leave a Reply

Your email address will not be published. Required fields are marked *

CCIE Enterprise Infrastructure

Collapse
Expand